This video will show you how to perform a standard ramping pickup test. Warning – This will be the ONLY time we show you how to test via a setting change.
Click “Mark Complete” below after watching the video so you can keep track of your progress.
Introduction to Relay Testing
16 Topics
Isolate the Relay from the System
2 Topics
Connect the Test-Set to the Relay
3 Topics
Upload the Relay Settings
2 Topics
Perform an Acceptance Test
5 Topics
How to Test Protective Elements
17 Topics
Perform a Commissioning Test
9 Topics
Perform Maintenance Tests
5 Topics
Post Testing Tasks
4 Topics
Relay spare Output 5 was connected to Input 5 of the test set during the acceptance testing, why did Input 1 indicate? Were the relay output connections altered?
Good eye. The programming for input 1 is still turned on. Most relay testers only monitor one input at a time and would only be connected to OUT5. I guess this “bad” habit of mine where I monitor all inputs derailed my argument a little because you could see OUT1 operate in the video and most relay test plans wouldn’t be looking there.
Thanks.